#Ricoh mpc2551 sc400 error code code#

In the next step, left the print head in the center of the device all while the printer was off.Now, raise up the grey bar by where the ink flows.Switch off the printer and take out all the cartridges of ink.Now, press the power button rapidly to start the reboot mode on the printer, the problem must be solved.Let the connectors dry completely and only then turn on your printer.

Detach and clean the print head as well as the connectors with the cue tips and alcohol of the gadget.

Turn off the printer and make sure it is not connected to any power outlet.

Now, wait for a minute and then turn your printer on again and check if the problem is resolved.

Reseat the print head of your device and turn it off.

Leave the Ricoh printer on and verify whether the issue is resolved.

You need to close the lid before the cartridges reach its destination.

Turn on the printer again you will see that the cartridges will start moving towards the left.Now in the next step, open the lid of the printer.Turn Off the Ricoh printer and disconnect it from the power source.Other than this you can try the following methods to fix the printer error. Make sure you clean all the five sensors. If in case you are unable to reach the sensors of the printer, you can make use of canned air to clean them. You can also make use of a tiny bit of alcohol for cleaning purpose. You can wipe out the dust with the help of a soft dry cloth. To stop such error from emerging, you should often clean the sensor yourself. There can be many causes behind the occurrence of this error which may include ID sensor fittings, loose connector, broken, defective sensor, dirty ID sensor dirty, defective ID sensor, defective IOB, BCU faulty, LD unit broken, CGB/PPG power pack issue, etc.

#Ricoh mpc2551 sc400 error code code#

Error code SC400 is another most commonly occurring error code that takes place in the Ricoh MP C2500 printer.